Post Finder
Forming characteristics of modified plastic

What are the main process characteristics of modified plastics?

1.Nylon is susceptible to moisture.

In the atmosphere, the equilibrium water absorption rate of PA is 3.5%, 2.5% of PA66, 1.5% of PA610 and 0.8% of PA1010.

The water content of nylon has great influence on its mechanical properties. In the molten state, the presence of water will cause the hydrolysis of nylon resulting in molecular weight

To reduce the mechanical properties of the products, but also in the molding of the surface of the products appear bubbles, silver and markings and other defects. So it must be full before forming Dry.

2. Nylon melt has low viscosity and high fluidity, and the nozzle will produce “casting” phenomenon. Waste raw materials, contaminate nozzles. If you use a screw injection

Machine molding, injection, melt will appear between the screw and the cylinder wall countercurrent, so that the injection is not allowed, so, nylon in screw injection machine molding, the end of the screw must be installed in the reverse ring.

3. Nylon is a crystalline polymer. The melting point is obvious, and higher, so nylon needs to be formed at a higher temperature

Poor thermal stability, easy to decompose. Therefore, the technological conditions must be strictly controlled.

4 nylon molding shrinkage rate is large,

for the manufacture of high precision products, mold design should be based on the test to determine its size, molding process should be strictly controlled.

 

recent articles

How to Choose the Appropriate POE Grafted Maleic Anhydride for Improving Nylon Toughness?

Designed especially to be an impact moderator for PA6, PA66, and polyamide systems needing reinforcement and filling, Coace® W1A-F is Its special qualities make it the perfect choice for uses where enhanced resistance to impact and toughness are most critical.

Read More →

New breakthrough in PBT modification: revolutionary application of POE-g-GMA toughening agent

Using POE-g-GMA toughening agent in PBT modification not only addresses PBT material brittleness but also provides fresh plastic industry development directions.

Read More →

When adding fillers to PP/PE composite materials, is it necessary to add a compatibilizer?

If one wants to investigate the usage of PP-g-MAH compatibilizers, getting in touch with a professional chemical supplier can give samples and technical support. Talking with COACE helps one customise mixes to satisfy certain application needs.

Read More →

LEAVE US A MESSAGE