Post Finder

News

News Categories

Subscription Form

News

Application of Super Thermal Conductive Nylon in Headlight Heat Sinks

Heat sinks for electronic products are structural components with a wide range of applications, including consumer electronics, servers, motors, LED lighting products, etc., all involving …

Company News

Polyolefin-grafted maleic anhydride as compatibilizer for lignin-polypropylene composites

Adding lignin to polymers can improve the mechanical and physical properties. Compared with inorganic fillers, it has the advantages of low density, low cost and …

News

'W1B' Nylon, no fear of the cold

The fish are getting stronger in the super cold? Nylon is weaker? Nylon virgin resins are difficult to maintain good performance under super-low temperature working …

News

Improving the Mechanical Properties of LDPE by Reactive Extrusion of ABS Secondary Material

PM with 75:25 ratio of LDPE to ABS (physical mixing) and CM with 75:25:5 ratio of LDPE, ABS to MA (chemical mixing) were prepared by …

News

Nylon toughening, why choose 40:1 for extruder L/D ratio

The third factor of nylon toughening – the determination of the production process, that the nylon toughening modification, it is usually used twin-screw blending modification, …

Company News

Do a good job of nylon toughening, how to choose nylon

The previous section mentioned that a suitable toughening agent must be selected for nylon toughening. In this section, we share another important factor – how …

News

Effect of compatible agents on the interfacial bonding of graphene oxide/polypropylene composite fibers

Graphene oxide (GO) is an ideal additive for polymeric nanobased composite fibers. To improve the interfacial bonding and thermal stability of GO and PP composite …

Industry News

Energy consumption to be reduced by 50%, Mitsui Chemicals to build eco-friendly carbon fibre demonstration line

Mitsui Chemical Co,. Ltd. and Nippon Microwave Chemical Co., Ltd. will jointly establish a production facility to demonstrate the basic technology associated with the manufacture …

News

Why is the POE grafting maleic anhydride grafting rate controlled at 0.6-1.0?

Then here and you sort out, nylon toughening, it in the end there are two requirements, one is only the pursuit of normal temperature toughening, …

LEAVE US A MESSAGE